#Vectra c diagnostic software serial#
#Vectra c diagnostic software full#

For Windows 7, dotnetfx35_SP1 must be installed.

2005-2014 Nissan NV300 (Select Vivaro as the vehicle type).2001-2004 Nissan Primastar (Select Vivaro as the vehicle type).2001-2014 Renault Trafic (Select Vivaro as the vehicle type).Vectra A, Vectra B and Vectra C / Signum 1988 - 2008.Insignia 2009 - 2013 (limited programming on Insignia at the moment).Frontera A and Frontera B (limited coverage).Corsa A, Corsa B, Corsa C, Combo van and Corsa D - 1987 - 2014 (note: Fiat based Combo D not yet covered).Astra F, Astra G, Astra H and Astra J 1987 - 2014 (limited programming on Astra J at the moment).SWCAN- Dual-wire, Low Speed CAN BUS, 33.3 kpbs.MSCAN- Dual-wire, Medium Speed CAN BUS 95 kbps.HSCAN- Dual-wire, High Speed CAN BUS, 500 kbps.You can also run output tests on many controllers: For example, an older system like the Omega-B 25 DT Engine (ISO-9141-2) can be very slow during communication, while the newer Multec or Bosch units are faster (using KWP-2000) and the newest CAN based control units are even faster. The same rate depends on the communication protocol. The software is capable of showing 8 measuring block parameters simultaneously.The software shows you the measuring block information on many control modules (select from the list).From the fault codes window, you can go directly to the measuring blocks window You can copy, save or print out the fault codes.

#Vectra c diagnostic software full#

Full Status Information (Present, Not Present, Intermittent).

Genuine Microchip PIC18F458 Micro-controller.

#Vectra c diagnostic software serial#

Genuine FTDI FT232RL USB Serial Converter.Compatible with Windows XP 7 8 10 32/64 bit.Fault codes will be shown with all information that's available.Since Opel uses many pins on the OBDII port, the diagnostic interface works as a multiplexer, selecting the appropriate pin for communication.Supports control units such as Engine, Transmission, ABS, Airbag, Engine Cooling Module, Instrument Cluster, Climate Control, BCM and more.Software allows you to read and erase fault codes, view live data and perform output tests.Supports most Opel vehicles up to year 2014, including newer models with CAN BUS, including the Vectra-C, Astra-H and Zafira-B.The OP-COM V1.7 Diagnostic Interface is a Windows PC based diagnostic tool specifically designed for Opel and Vauxhall vehicles up to year 2014 and allows full diagnostics such as reading/clearing codes, live data, output tests and also allows you to communicate with many of the control modules such as the Engine, Transmission, Airbag, Instrument Cluster, BCM and more.